Security group tree – HP XP P9500 Storage User Manual
Page 307
Use Volume Security for Mainframe to display settings and make changes to security groups.
Description
Item
Displays the security, host, and LDEV groups assigned to the LDKC defined on
the storage system. For details see
.
Security Group Tree
Displays the type, model, SEQNUMBER, Logical Partition (LPAR) and vendor of
each host. For details, see
Hosts table
Allows you to select the desired command units available in each group. When
you select a CU image, the table below shows a list of volumes in the selected
CU image.
CU List
Applies the requested XRC setting changes to the storage system.
Apply
Discards the requested changes without applying them to the storage system. A
confirmation message appears to allow you to cancel the requested operations.
Cancel
Click OK to cancel the requested operations, or Cancel to keep, but not start,
the requested operations.
Security Group Tree
From the Security Group tree, you can select the LDKC (logical disk controller), then click a security
group, host group, or LDEV group that resides on the LDKC.
When you click LDKC:00, you can choose from these options:
•
Security Group to select a host group or LDEV group listed in a security group.
•
Host Group to select a specific host group from those listed.
•
LDEV Group to see the host groups and LDEV groups registered to a security group.
To make changes to a group, right-click a group or the group node in the tree, then select
Add/Change from the pop-up menu.
Volume Security for Mainframe window 307