HP Business Inkjet 2600 Printer series - Manual (Page 34)

4-2 ENWW
Note HP Business Inkjet 2600dn comes with an HP Jetdirect 615n (EIO)
internal print server installed. It is recommended that the printer be
shared on a network through the print server.
If you own the HP Business Inkjet 2600dn, skip step 1.
If you own an HP Business Inkjet 2600, you can purchase an
HP Jetdirect internal print server for it. For the list of HP Jetdirect print
servers, see “Networking accessories.”
Step 1: Install the HP Jetdirect EIO print server
CAUTION The HP Jetdirect print server contains electronic components that can
be damaged by static electricity. To prevent buildup of static electricity,
maintain frequent contact with any bare sheet metal surface on the
printer. If possible, wear a grounding wrist strap (or similar device).
Handle the print server carefully at all times. Avoid touching electronic
components or circuit paths.
1 Turn off the printer and unplug the power cord.
2 Unscrew and remove the metal plate on the back of the printer.
3 Insert the print server. Align the print server with the guide rails in
the printer.
4 Press the print server into the slot until it is firmly seated.
5 Tighten each thumbscrew a little at a time, alternating between
each side until both screws are secure.
6 Connect the network cable to the print server.