HP Business Inkjet 2600 Printer series - Manual (Page 26)

3-2 ENWW
Installing the printer software and connecting the
interface cable
Use a USB cable or a network (Ethernet) cable to connect the printer to
the computer.
Connecting the printer with a USB cable
Note When setting up the printer using a USB cable, install the software first,
and then connect the printer to the computer.
1 Insert the Starter CD into the CD-ROM drive. The CD menu runs
automatically.
If the CD menu does not run automatically, double-click the CD icon
on the desktop, and then double-click the ClassicInstaller icon (if
you are using Mac OS 8.6 to Mac OS 9.1) or the CarbonInstaller
icon (if you are using Mac OS X). This icon is located in the
Installer: folder of the Starter CD (where is
your language preference).
2 Follow the instructions on the screen.
3 Connect the cable between the ports on the computer and the
printer.
4 If you are using Mac OS 8.6 to Mac OS 9.1, complete steps 5
through 9.
-Or-
If you are using Mac OS X, complete steps 10 through 13.
Mac OS 8.6 to Mac OS 9.1
5 Open the Desktop Printer Utility:
• Mac OS 8.6 to Mac OS 9.0.x: On the hard drive, double-click
the Desktop Printer Utility icon in the Apple Extras: Apple
LaserWriter Software folder.
• Mac OS 9.1: On the hard drive, double-click the Desktop Printer
Utility icon in the Applications (Mac OS 9): Utilities folder.
6 Select LaserWriter8 from the pop-up menu, select Printer (USB)
from the list, and then click OK .