Iscsi initiator setup for linux, 32 presented eva luns, Figure 32 – HP EVA Array iSCSI Connectivity Option User Manual
Page 75
Figure 32 Presented EVA LUNs
NOTE:
If no LUNs appear in the list, log out and then log in again to the target, or a system reboot may be
required.
3.
Set up the iSCSI drive on the iSCSI Initiator:
a. Open Disk Utilities from the Apple Max OS X Finder Applications list.
b. Format and partition the EVA LUN as needed.
iSCSI Initiator setup for Linux
Installing and configuring the SUSE Linux Enterprise 10 iSCSI driver
Configure the initiator using the built-in GUI-based tool or the open-iscsi administration utility using the
iscsiadm
command. See the iscsiadm (8) man pages for detailed command information.
1.
Modify the Initiator Name by issuing the following command:
# vi /etc/initiatorname.iscsi
2.
To configure the Initiator and Targets, start the iSCSI Initiator applet by finding it in the YaST Control
Center under Network Services, and then set the service to start at boot time (
).
EVA iSCSI connectivity user guide
75