HP EVA Array iSCSI Connectivity Option - Manual (Page 156)

Authority Admin session
Syntax
set isns []
Parameters
port_num
: The number of the iSCSI port to be configured for iSNS.
Examples The following is an example of the set isns command:
mpx100 (admin) #> set isns
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the Enter key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the Enter key to do so.
Configuring iSNS iSCSI Port: 1
——————————–
iSNS (0=Enable, 1=Disable) [Disabled ] 0
IP Address [0.0.0.0 ] 10.0.0.3
TCP Port No. [3205 ]
All attribute values for Port 1 that have been changed will now be saved.
Configuring iSNS iSCSI Port: 2
——————————–
iSNS (0=Enable, 1=Disable) [Disabled ]
All attribute values for Port 2 that have been changed will now be saved.
Set MGMT command
Configures the mpx100/100b management port (10/100).
Authority Admin session
Syntax set mgmt
Parameters
port_num
: The number of the iSCSI port to be configured for iSNS.
Examples The following is an example of the set mgmt command:
mpx100 (admin) #> set mgmt
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the Enter key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the Enter key to do so.
Mode (0=Static, 1=DHCP, 2=Bootp, 3=Rarp) [Dhcp ] 1
IP Address [10.0.0.1 ]
Subnet Mask [255.0.0.0 ]
Gateway [0.0.0.0 ]
All attribute values that have been changed will now be saved.
mpx100 (admin) #> set mgmt
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the Enter key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the Enter key to do so.
Mode (0=Static, 1=DHCP, 2=Bootp, 3=Rarp) [Static ] 1
All attribute values that have been changed will now be saved.
Set NTP command
Configures NTP parameters.
156 Command line interface