HP EVA Array iSCSI Connectivity Option - Manual (Page 62)

System Symbolic Name (Max = 64 characters) [ ] MPX100-65
Embed Symbolic Name (0=Enable,1=Disable) [Disabled ]
System Log Level (Min = 0, Max = 3) [0 ]
NOTE:
The Symbolic Name syntax must follow the iSCSI standard for IQN naming. Only the following ASCII
characters (U+0000 to U+007F), are allowed:
• ASCII dash character (-) = U+002d
• ASCII dot character (.) = U+002e
• ASCII colon character (:) = U+003a
• ASCII lower-case characters (a through z) = U+0061 through U+007a
• ASCII digit characters (0 through 9) = U+0030 through U+0039
See section 3.2.6 of Request for Comments (RFC) 3720 (iSCSI) for a description of the iSCSI name string
profile. You can access RFC 3720 at the ftp site: ftp://ftp.rfc-editor.org/in-notes/rfc3720.txt.
3. Enable the Embed Symbolic Name option.
When this setting is enabled, the mpx100/100b embeds the symbolic name as part of the Target
IQN on the iSNS server. This also helps users to recognize the target if multiple mpxs are registered
with the same iSNS server.
System Symbolic Name (Max = 64 characters) [ ] MPX100-65
Embed Symbolic Name (0=Enable,1=Disable) [Disabled ]0
System Log Level (Min = 0, Max = 3) [0 ]
4. Reboot the mpx100/100b.
The new attribute values are saved and in effect.
5. After enabling the iSCSI port for iSNS, verify that an iSCSI port target entry appears in the iSNS
server database.
Example 1. iSNSCLI command issued on iSNS server
C:> isnscli listnodes
.
.
.
iqn.1986-03.com.hp:fcgw.mpx100:mpx100-65.1.50001fe150002f70.50001fe150002f7f
Where:
iqn.1986-03.com.hp:fcgw.mpx100 The standard iqn name for all mpx100's/100b's
mpx100-65 Symbolic Name
1 iSCSI port number
50001fe150002f70.50001fe150002f7f Presented EVA port
Installing the mpx100/100b firmware
The mpx100/100b ships with the latest firmware installed. You can upgrade the firmware from the
management server. You can use the HP StorageWorks mpx Manager application or the CLI to install
new firmware.
62 Configuring the mpx100/100b