HP EVA Array iSCSI Connectivity Option - Manual (Page 192)

Table 33 SNMP parameters
Parameter Description
Trap n Enabled Enables or disables trap n. If disabled, the trap is not configured.
Trap Address 1
Specifies the IP address to which the SNMP traps are sent. A maximum of 8
trap addresses are supported. The default address for traps is 0.0.0.0.
Trap Port 1 The port number on which the trap is sent. The default is 162.
Trap Version Specifies the SNMP version (1 or 2) with which to format traps.
1 Trap address (other than 0.0.0.) and trap port combinations must be unique. For example, if trap 1 and trap 2 have the
same address, then they must have different port values. Similarly, if trap 1 and trap 2 have the same port value, they must
have different addresses.
Management Information Base
The following sections describe the components of the Management Information Base (MIB):
• System information , page 192
• Network port table , page 193
• Fibre Channel port table , page 195
• Sensor table , page 197
System information
The system information objects provide the system serial number, version numbers
(hardware/software/agent), and number of ports (FC/GE).
qsrSerialNumber
Syntax
SnmpAdminString
Access read-only
Description The system serial number
qsrHwVersion
Syntax
SnmpAdminString
Access read-only
Description The system hardware version number
qsrSwVersion
Syntax
SnmpAdminString
Access read-only
Description The system software (firmware) version number
qsrNoOfFcPorts
Syntax
Unsigned32
Access read-only
Description The number of FC ports on the system
192 Simple Network Management Protocol