HP EVA Array iSCSI Connectivity Option - Manual (Page 110)

5. To enable the changes, enter the SMS password: config.
6. Select the Target Settings tab. Verify that the HBA state is Ready, Link Up and each target entry’s
state is Session Active ( Figure 60 ).
Figure 60 Target settings tab
Presenting LUNs to the QLogic iSCSI Initiator
To present LUNs to the QLogic iSCSI Initiator:
1. Follow procedures in “ Creating an iSCSI initiator host via HP Command View EVA ” on page 130 to:
• Create an iSCSI host entry, and
• Present LUNs to the iSCSI host
2. On the iSCSI HBA tab ( Figure 61 ) verify that the QLogic iSCSI HBA is connected to the iSCSI LUNs
in SMS under the HBA iSCSI port.
110 Setting up the iSCSI Initiator for multipathing