HP EVA Array iSCSI Connectivity Option - Manual (Page 152)

Reset command
Restores the mpx100/100b configuration parameters to the factory default values. All LUN mappings
are deleted as is all persistent data regarding targets, LUN,s and initiators. The factory default IP
addresses is restored.
Authority Admin session.
Syntax reset
Keywords
factory
: Restores the mpx100/100b to its factory default configuration.
Examples The following is an example of the reset command:
mpx100 (admin) #> reset factory
Are you sure you want to restore to factory default settings (y/n): y
Please reboot the System for the settings to take affect.
Save command
Saves logs and traces.
Authority Admin session only
Syntax save
logs
traces
capture
Keywords
logs
: Creates a tar file containing the mpx100/100b log data, storing the file
in the mpx100/100b /var/ftp directory. The operator must ftp the logs tar
file from the mpx100/100b.
traces
: Creates a tar file containing the mpx100’s/100b's dump data,
storing the tar file in the mpx100/100b /var/ftp directory. The operator
must ftp the traces tar file from the mpx100/100b. If the mpx100/100b does
not have any dump data, the operator is notified during command execution.
An event log entry is generated whenever dump data is generated.
capture
: Creates a file with all the vital data from the mpx100/100b,
including firmware versions and log files.
Examples The following is an example of the save logs command:
mpx100 (admin) #> save logs
Save Event Logs completed. Package is mpx100_Evl.tar.gz
Please use FTP to extract the file out from the System.
The following are two examples of the save traces command:
mpx100 (admin) #> save traces
Save ASIC Traces completed. Package is mpx100_Asic_Trace.tar.gz
Please use FTP to extract the file out from the System.
mpx100 (admin) #> save traces
No ASIC trace files exist to save. Command aborted.
Set command
Configures general mpx100/100b parameters as well as the parameters for the Fibre Channel, iSCSI,
and management ports.
152 Command line interface