Removing a radius server – HP M-series HA-Fabric Manager Software User Manual
Page 67
McDATA® 4Gb SAN Switch for HP p-Class BladeSystem user guide
67
5.
Enter the remote UDP port number of the Authentication RADIUS Server in the
UDP Port field.
The RADIUS Accounting Server UDP port will always be the value of Device/User Authentication Server
UDP Port + 1. When enabled, the RADIUS Accounting Server audits user activity whether
UserAuthServer is enabled or not. The RADIUS Accounting Server default is False.
6.
Enter the timeout value in seconds (minimum of 1 second, maximum of 30 seconds) in the
Timeout
field. This is the number of seconds the RADIUS client will wait for a response from the RADIUS server
before retrying, or giving up on a request.
7.
Enter the number of retries in the
Retries field. This is the maximum number of times the RADIUS client
will retry a request sent to the primary RADIUS server.
8.
Select
Sign Packet to enable the switch to include a digital signature (Message-Authenticator) in all
RADIUS access request packets sent to the RADIUS server. A valid Message-Authenticator attribute will
be required in all RADIUS server responses.
9.
Enter the server secret in the
Secret field. A secret is required for all RADIUS servers. The secret is used
when generating and checking the Message-Authenticator attribute.
10.
Click
Add Server to add the server.
11.
Click
Modify Authentication Order tab, and verify that Device Authentication Order and User
Authentication Order options are set to Radius or Radius Local. See ”
” on page 69 for more information.
a. RADIUS—Only attempts to authenticate using the RADIUS server (another computer that provides
authentication).
b. RADIUS Local—Attempts to authenticate using the RADIUS server. If the switch can not contact the
RADIUS server due to a network or some other problem, the switch will authenticate using the local
password database.
12.
Click
Close to close the Radius Server Information dialog.
Removing a RADIUS server
Removing a RADIUS server, disables the remote authentication of devices or users over the network.
Figure 30
RADIUS Server Information dialog—Remove Server tab page
To remove a RADIUS server, perform the following procedure:
1.
Select
Switch > Radius Servers in the faceplate display.
2.
Click the
Remove Server tab in the Radius Server Information dialog shown in
3.
Select the server to be removed in server list at the top of the dialog.
4.
Click
Remove Server to remove the server.
5.
Click
Close to close the Radius Server Information dialog.