HP M-series HA-Fabric Manager Software - Manual (Page 150)

150 Command Line Interface
Enter the Show Setup Services command to display switch service configuration values.
Enter the Show Setup System command to display system configuration values.
Enter the Show Config Security command to display security configuration values.
Table 41 Services configuration defaults
Parameter Default
TelnetEnabled True
SSHEnabled False
GUIMgmtEnabled True
SSLMgmtEnabled False
EmbeddedGUIEnabled True
SNMPEnabled True
NTPEnabled False
CIMEnabled True
FTPEnabled True
MgmtServerEnabled False
Table 42 System configuration defaults
Parameter Default
Ethernet Network Discovery Static
Ethernet Network IP Address 10.0.0.1
Ethernet Network IP Mask 255.0.0.0
Ethernet Gateway Address 10.0.0.254
Admin Timeout 30 minutes
InactivityTimeout 0
LocalLogEnabled True
RemotelogEnabled False
RemoteLogHostAddress 10.0.0.254
NTPClientEnabled False
NTPServerAddress 10.0.0.254
EmbeddedGUIEnabled True
Table 43 Security configuration defaults
Parameter Default
FabricBindingEnabled True
AutoSave True
See also Hardreset command , page 134
Hotreset command , page 137
Set Log command , page 168