HP M-series HA-Fabric Manager Software - Manual (Page 120)

120 Command Line Interface
Config command
Description Manages the FC configurations on a switch. For information about setting the port and switch
configurations, see the Set Config command.
Authority Admin session for all operands except List.
Syntax
config
activate [config_name]
backup
cancel
copy [config_source] [config_destination]
delete [config_name]
edit [config_name]
list
restore
save [config_name]
Operands
activate [config_name]
Activates the configuration given by [config_name]. If you omit [config_name], the currently
active configuration is used. Only one configuration can be active at a time.
backup
Creates a file named configdata, which contains the system configuration information. To
download this file, open an FTP session, log in with account name/password of “images” for
both, and enter “get configdata”. See ”
Backing up and restoring switch configurations ” on
page 111.
cancel
Terminates the current configuration edit session without saving changes that were made.
copy [config_source] [config_destination]
Copies the configuration given by [config_source] to the configuration given by
[config_destination]. The switch supports up to 10 configurations including the default
configuration.
delete [config_name]
Deletes the configuration given by [config_name] from the switch. You cannot delete the default
configuration (Default Config) nor the active configuration.
edit [config_name]
Begins an edit session for the configuration given by [config_name]. If you omit [config_name],
the currently active configuration is used.
list
Displays a list of all available configurations on the switch. This operand does not require an
Admin session.