HP M-series HA-Fabric Manager Software User Manual
Page 167
McDATA® 4Gb SAN Switch for HP p-Class BladeSystem user guide 167
The following is an example of the Set Config Zoning command.
McDATA4GbSAN #> admin start
McDATA4GbSAN (admin) #> config edit
McDATA4GbSAN (admin-config) #> set config zoning
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
InteropAutoSave (True / False) [True ]
DefaultZone (True / False) [False]
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
See also