HP M-series HA-Fabric Manager Software - Manual (Page 181)

McDATA® 4Gb SAN Switch for HP p-Class BladeSystem user guide 181
cimlistener [listener_name]
Displays CIM indicator services listener information for the listener given by [listener_name]. If
you omit [listener_name], the command displays all listeners.
config [option]
Displays switch, port, and zoning configuration attributes. See the Show Config command.
domains
Displays list of each domain and its World Wide Name in the fabric.
fabric
Displays list of each domain, symbolic name, World Wide Name, node IP address, and port IP
address.
fdmi [port_wwn]
Displays detailed information about the device host bus adapter given by [port_wwn]. If you omit
[port_wwn], the command displays a summary of host bus adapter information for all attached
devices in the fabric. Illegal characters in the display appear as question marks (?).
interface
Displays the status of the active network interfaces.
log [option]
Displays log entries. See the Show Log command. The log is cleared when the switch is reset or
power cycled.
lsdb
Displays Link State database information.
mem [count]
Displays information about memory activity for the number of seconds given by [count]. If you
omit [count], the value 1 is used. Displayed memory values are in 1K block units.
NOTE:
This operand will display memory activity updates until [count] is reached – it cannot
be interrupted. Therefore, avoid using large values for [count].
ns [option]
Displays name server information for the specified [option]. If you omit [option], name server
information for the local domain ID is displayed. [option] can have the following values:
all
Displays name server information for all switches and ports.
[domain_id]
Displays name server information for the switch given by [domain_id]. [domain_id] is a switch
domain ID.
[port_id]
Displays name server information for the port given by [port_id]. [port_id] is a port FC
address.
pagebreak
Displays the current pagebreak setting. The pagebreak setting limits the display of information to
20 lines (On) or allows the continuous display of information without a break (Off).
perf [option]
Displays performance information for all ports. See the Show Perf command.
port [port_number]
Displays operational information for the port given by [port_number]. External ports are
numbered 0 and 9; internal ports are numbered 1–8. If [port number] is omitted, information is
displayed for all ports.
Table 53 describes the port parameters.