HP M-series HA-Fabric Manager Software - Manual (Page 154)

154 Command Line Interface
Securityset command
Description Manages security sets in the security database.
NOTE: This command is available only with the SANtegrity Enhanced PFE key.
Authority Admin session and a Security Edit session. See the Security command for information about
starting a Security Edit session. The Active, Groups, and List operands are available without an
Admin session. You must end the Security Edit session before using the Activate and Deactivate
operands.
Syntax
securityset
activate [security_set]
active
add [security_set] [group_list]
copy [security_set_source] [security_set_destination]
create [security_set]
deactivate
delete [security_set]
groups [security_set]
list
remove [security_set] [group]
rename [security_set_old] [security_set_new]
Operands
activate [security_set]
Activates the security set given by [security_set]. This operand deactivates the active security set.
End the Security Edit session using the Security Save or Security Cancel command
before using this operand.
active
Displays the name of the active security set. This operand is available to without an Admin
session.
add [security_set] [group_list]
Adds one or more groups given by [group_list] to the security set given by [security_set]. Use a
to delimit multiple group names in [group_list]. A security set can have a maximum of
three groups with no more than one group of each group type.
copy [security_set_source] [security_set_destination]
Creates a new security set named [security_set_destination] and copies into it the membership
from the security set given by [security_set_source].
create [security_set]
Creates the security set with the name given by [security_set]. A security set name must begin
with a letter and be no longer than 64 characters. Valid characters are 0—9, A—Z, a—z, _, $,
^, and -. The security database supports a maximum of 4 security sets.
deactivate
Deactivates the active security set. End the Security Edit session before using this operand.
delete [security_set]
Deletes the security set given by [security_set]. If the specified security set is active, the command
is suspended until the security set is deactivated.
groups [security_set]
Displays all groups that are members of the security set given by [security_set]. This operand is
available without an Admin session.