HP M-series HA-Fabric Manager Software - Manual (Page 172)

172 Command Line Interface
Set Setup command
Description Manages configuration settings for Remote Authentication Dial-In User Service (RADIUS) servers,
switch services, SNMP, and system configurations.
Authority Admin session
Syntax
set setup
radius
services
snmp
system
Operands
radius
Prompts you in a line-by-line fashion to configure RADIUS servers for user account and device
authentication.
Table 49 describes the RADIUS server configuration fields.
Table 49 RADIUS service settings
Entry Description
DeviceAuthOrder
IMPORTANT: This setting is valid only with the SANtegrity
Enhanced PFE key
Authenticator priority for devices:
•
Local—Authenticate devices using only the local security database.
This is the default.
•
Radius—Authenticate devices using only the security database on the
RADIUS server.
•
RadiusLocal—Authenticate devices using the RADIUS server security
database first. If the RADIUS server is unavailable, then use the local
switch security database.
UserAuthOrder Authenticator priority for user accounts:
•
Local—Authenticate users using only the local security database. This
is the default.
• Radius—Authenticate users using only the security database on the
RADIUS server.
• RadiusLocal—Authenticate users using the RADIUS server security
database first. If the RADIUS server is unavailable, then use the local
switch security database.
TotalServers Number of RADIUS servers to configure during this session. Setting
TotalServers to 0 disables all RADIUS authentication. The default is 0.
ServerIPAddress IP address of the RADIUS server. The default is 10.0.0.1.
ServerUDPPort User Datagram Protocol (UDP) port number on the RADIUS server. The
default is 1812.
DeviceAuthServer
IMPORTANT:
This setting is valid only with the SANtegrity
Enhanced PFE key
Enable (True) or disable (False) this server for device authentication. The
default is False.