HP M-series HA-Fabric Manager Software - Manual (Page 160)

160 Command Line Interface
security
Initiates an edit session in which to change the security settings. The system displays each
parameter one line at a time and prompts you for a value. For each parameter, enter a new
value or press
Enter to accept the current value shown in brackets. Press q or Q to end the editing
session. Table 45 describes the Set Config Security parameters.
IMPORTANT: This operand is available only with the SANtegrity Enhanced PFE key.
Table 45 Security configuration parameters
Parameter Description
FabricBindingEnabled Enables (True) or disables (False) the configuration and enforcement
of fabric binding on all switches the fabric. Fabric binding associates
switch World Wide Names with a domain ID in the creation of ISL
groups.
AutoSave Enables (True) or disables (False) the saving of changes to active
security set in the switch permanent memory. The default is True.
switch
Initiates an edit session in which to change switch configuration settings. The system displays
each parameter one line at a time and prompts you for a value. For each parameter, enter a new
value or press
Enter to accept the current value shown in brackets.
Table 46 describes the Set
Config Switch parameters.
Table 46
Set Config switch parameters
Parameter Description
AdminState Switch administrative state: Online, Offline, or Diagnostics. The default is
Online.
BroadcastEnabled Broadcast. Enables (True) or disables (False) forwarding of broadcast
frames. The default is True.
InbandEnabled Inband management. Enables (True) or disables (False) the ability to
manage the switch over an ISL. The default is True.
FDMIEnabled Fabric Device Monitoring Interface. Enables (True) or disables (False) the
monitoring of target and initiator device information. The default is True.
FDMIEntries The number of device entries to maintain in the FDMI database. Enter a
number from 0–1000. The default is 1000.
DefaultDomainID Default domain ID. The default is 1.
DomainIDLock Prevents (True) or allows (False) dynamic reassignment of the domain ID.
The default is False.
SymbolicName Descriptive name for the switch. The name can be up to 32 characters
excluding #, semicolon (;), and comma (,). The default is
McDATA4GbSAN.
R_A_TOV Resource Allocation Timeout Value. The number of milliseconds the
switch waits to allow two ports to allocate enough resources to establish
a link. The default is 10000.
E_D_TOV Error Detect Timeout Value. The number of milliseconds a port is to wait
for errors to clear. The default is 2000.