HP Photosmart C7200 Series - Manual (Page 54)

Use the Embedded Web Server setup wizard
The network setup wizard provided in the Embedded Web Server gives you an intuitive
interface to your network connection parameters.
To access the Embedded Web Server setup wizard
1. Print a network configuration page to find the IP address for the HP All-in-One.
2. In the Address box in your Web browser on your computer, type the IP address of
the HP All-in-One, as shown on the network settings page. For example, http://
192.168.1.101.
The Embedded Web Server Home page appears, showing information for the HP All-
in-One.
NOTE: If you are using a proxy server in your browser, you might need to disable
it to access the Embedded Web Server.
3. Click the Networking tab.
4. Click Wired (802.3) or Wireless (802.11) in the Connections navigation menu.
5. Click Start Wizard, and then follow all of the wizard instructions.
Related topics
“View and print network settings” on page 49
Network configuration page definitions
The network configuration page shows the network settings for the HP All-in-One. There
are settings for general information, 802.3 wired (Ethernet), 802.11 wireless, and
Bluetooth
® .
This section contains the following topics:
• General network settings
• Wired (802.3) network settings
• Wireless (802.11) network settings
• Bluetooth settings
Related topics
• “View and print network settings” on page 49
• “Network glossary” on page 59
Connect to a network 53
Finish
set
up