HP Photosmart C7200 Series - Manual (Page 165)

To clean the ink cartridge contacts
1. Make sure the HP All-in-One is turned on.
2. Lift the ink cartridge door.
3. Squeeze the bottom of the latch below the ink cartridge you want to clean, and then
lift the latch.
NOTE: Do not remove multiple ink cartridges at the same time. Remove and
clean each ink cartridge one at a time. Do not leave an ink cartridge outside the
HP All-in-One for more than 30 minutes.
4. Inspect the ink cartridge contacts for ink and debris buildup.
5. Dip a clean foam rubber swab or lint-free cloth into distilled water, and squeeze any
excess water from it.
NOTE: Hold the ink cartridge by its handle. Do not touch the copper-colored
contacts with your hands or anything other than a foam rubber swab or lint-free
cloth.
6. Clean only the copper-colored contacts.
1 Copper-colored contacts
7. Place the ink cartridge back into the empty slot and press down on the gray latch until
it clicks into place.
8. Repeat if necessary for the other ink cartridges.
9. Gently close the ink cartridge door.
Remove ink from your skin and clothing
Follow these instructions to remove ink from your skin and clothing:
Surface Remedy
Skin Wash the area with an abrasive soap.
White fabric Wash the fabric in cold water and use chlorine bleach.
Chapter 13
164 Maintain the HP All-in-One
Maintain
the HP All-in-One