HP Photosmart C7200 Series User Manual
Page 179
Solution: Check that the ink cartridges are installed properly and have ink.
For more information, see:
“Work with ink cartridges” on page 158
Cause: The HP All-in-One might not be turned on.
Solution: Look at the display on the HP All-in-One. If the display is blank and the
On button is not lit, the HP All-in-One is turned off. Make sure the power cord is firmly
connected to the HP All-in-One and plugged into a power outlet. Press the On button
to turn on the HP All-in-One.
Cause: The HP All-in-One might be out of paper.
Solution: Load paper in the input tray.
For more information, see:
I received a message on the display to install the Two-sided module
Cause: The Two-sided printing accessory is not installed correctly.
Solution: If the Two-sided printing accessory is installed, remove it and reinstall it.
To reinstall it, press the buttons on each side of the accessory and push it into the
rear of the HP All-in-One until it clicks into place.
If the Two-sided printing accessory is not installed, install it at the rear of the HP All-
in-One.
I received a message on the display about a paper jam or a blocked print head
assembly
Cause: The HP All-in-One has a paper jam.
Solution: Clear the paper jam, and then follow the prompts on the display or the
computer screen to continue.
For more information, see:
“Clear paper jams” on page 171
Chapter 15
178
Troubleshooting
T
roub
les
hoot
ing