HP Photosmart C7200 Series - Manual (Page 269)

Cannot load paper from input tray
Cause: There is not enough paper in the input tray.
Solution: If the HP All-in-One is out of paper or there are only a few sheets
remaining, load more paper in the input tray. If there is paper in the input tray, remove
the paper, tap the stack of paper against a flat surface, and reload the paper into the
input tray. Follow the prompts on the display or the computer screen to continue your
print job.
For more information, see:
“Load full-size paper” on page 76
Ink is drying
Cause: Transparencies and some other media require a drying time that is longer
than normal.
Solution: Leave the sheet in the output tray until the message disappears. If it is
necessary to remove the printed sheet before the message disappears, carefully hold
the printed sheet on the underside or the edges, and place it on a flat surface to dry.
Out of paper
Cause: There is not enough paper in the input tray.
Solution: If the HP All-in-One is out of paper or there are only a few sheets
remaining, load more paper in the input tray. If there is paper in the input tray, remove
the paper, tap the stack of paper against a flat surface, and reload the paper into the
input tray. Follow the prompts on the display or the computer screen to continue your
print job.
For more information, see:
“Load full-size paper” on page 76
Cause: The Two-sided printing accessory is not connected to the HP All-in-One.
Solution: If you removed the Two-sided printing accessory to clear a paper jam,
replace it.
For more information, see:
“Clear paper jams” on page 171
Paper jam, misfeed or blocked print head assembly
Cause: Paper has jammed the HP All-in-One.
Solution: Clear the jam. To continue your print job, press OK on the control panel
of the HP All-in-One.
Chapter 15
268 Troubleshooting
T
roub
les
hoot
ing