HP Photosmart C7200 Series User Manual
Page 177
•
Test the power outlet to make sure it is working. Plug in an appliance that you
know works, and see if the appliance has power. If not, then there might be a
problem with the power outlet.
•
If you plugged the HP All-in-One into a switched outlet, make sure the switch is
on. If it is switched to on but still does not work, then there might be a problem
with the power outlet.
Cause: You pressed the On button too quickly.
Solution: The HP All-in-One might not respond if you press the On button too
quickly. Press the On button once. It might take a few minutes for the HP All-in-One
to turn on. If you press the On button again during this time, you might turn the device
off.
WARNING!
If the HP All-in-One still does not turn on, it might have a mechanical
failure. Unplug the HP All-in-One from the power outlet and contact HP. Go to:
If prompted, choose your country/region, and then click Contact HP for
information on calling for technical support.
I connected the USB cable, but I am having problems using the HP All-in-One with
my computer
Cause: The USB cable was connected before the software was installed.
Connecting the USB cable before prompted can cause errors.
Solution: You must first install the software that came with the HP All-in-One before
connecting the USB cable. During installation, do not plug in the USB cable until
prompted by the onscreen instructions.
Once you have installed the software, connecting your computer to the HP All-in-One
with a USB cable is straightforward. Simply plug one end of the USB cable into the
back of your computer and the other into the back of the HP All-in-One. You can
connect to any USB port on the back of your computer.
Chapter 15
176
Troubleshooting
T
roub
les
hoot
ing