HP Color LaserJet 4700 Printer series - Manual (Page 98)

Setting the default gateway
1. Press Menu to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press to select I/O.
6. Press to highlight the JETDIRECT menu.
7. Press to select the JETDIRECT menu.
8. Press to highlight TCP/IP.
9. Press to select TCP/IP.
10. Press to highlight MANUAL SETTINGS.
11. Press to select MANUAL SETTINGS.
12. Press to highlight DEFAULT GATEWAY.
13. Press to select DEFAULT GATEWAY.
NOTE The first set of the three sets of numbers shows the default settings. If there is not
a number highlighted, a highlighted empty underscore appears.
14. Press or to increase or decrease the number for configuring DEFAULT GATEWAY.
15. Press to move to the next set of numbers.
16. Repeat steps 15 and 16 until the correct subnet mask is entered.
17. Press the Menu button to return to the Ready state.
Disabling network protocols (optional)
By factory default, all supported network protocols are enabled. Disabling unused protocols has the
following benefits:
● Decreases printer-generated network traffic.
● Prevents unauthorized users from printing to the printer.
● Provides only pertinent information on the configuration page.
● Allows the printer control panel to display protocol-specific error and warning messages.
NOTE TCP/IP configuration cannot be disabled on the HP Color LaserJet 4700 series printer.
82 Chapter 3 I/O configuration ENWW