HP Color LaserJet 4700 Printer series User Manual
Page 222
Control panel message
Description
Recommended action
Using black only
alternates with
out condition and the printer is set to
AUTOCONTINUE BLACK.
REPLACE TRANSFER KIT
For help press
The transfer unit is at end of life. Printing can
continue but print quality might be reduced.
1.
Open the top and front cover.
2.
Lower the transfer unit by pulling the
green handle at the top of the unit
downward.
3.
Depress the small blue latches located
on either side of the bottom of the
transfer unit and lift the unit out of the
printer.
4.
Install the new transfer unit.
5.
Close the front and top covers.
6.
Supplies ordering information is also
available from the embedded Web
server. See
for more information.
REPLACE TRANSFER KIT
For help press
alternates with
REPLACE TRANSFER KIT
To continue press
The transfer unit is nearing the end of its
useful life and the REPLACE SUPPLIES
setting in the SYSTEM SETUP menu is set to
STOP AT LOW.
1.
Order the transfer kit.
2.
To continue printing, press .
3.
To replace the transfer kit, perform the
following steps:
●
Open the top and front cover.
●
Lower the transfer unit by pulling
the green handle at the top of the
unit downward.
●
Depress the small blue latches
located on either side of the bottom
of the transfer unit and lift the unit
out of the printer.
●
Install the new transfer unit.
●
Close the front and top covers.
●
Supplies ordering information is
also available from the embedded
Web server. See
for more
information.
Request accepted
please wait
The printer has accepted a request to print an
internal page, but the current job must finish
printing before the internal page will print.
No action necessary.
Resend
upgrade
The firmware upgrade was not completed
successfully.
Attempt upgrade again.
Restoring...
[accessory #]
The printer is restoring external accessory
settings in response to a user request.
No action necessary.
206
Chapter 8 Problem solving
ENWW