HP Color LaserJet 4700 Printer series - Manual (Page 96)

Network configuration
You might need to configure certain network parameters on the printer. You can configure these
parameters from installation software, the printer control panel, the embedded Web server, or
management software, such as HP Web Jetadmin or the HP LaserJet Utility for Macintosh.
NOTE For more information about using the embedded Web server, see Using the embedded
Web server .
For more information about supported networks and network configuration tools, see the HP Jetdirect
Print Server Administrator’s Guide. The guide comes with printers in which an HP Jetdirect print server
is installed.
This section contains the following instructions for configuring network parameters from the printer
control panel:
● Configuring TCP/IP parameters.
● Disabling unused network protocols.
Configuring TCP/IP parameters
You can use the printer control panel to configure these TCP/IP parameters:
● IP address (4 bytes)
● Subnet mask (4 bytes)
● Default gateway (4 bytes)
Manually configuring TCP/IP parameters from the printer control panel
Use manual configuration to set an IP address, subnet mask, and default gateway.
Setting an IP address
1. Press Menu to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press to select I/O.
6. Press to highlight the JETDIRECT menu.
7. Press to select the JETDIRECT menu.
8. Press to highlight TCP/IP.
9. Press to select TCP/IP.
10. Press to highlight MANUAL SETTINGS.
11. Press to select MANUAL SETTINGS.
80 Chapter 3 I/O configuration ENWW