HP OneView - Manual (Page 256)

Table 18 Development networks
VLAN ID Name
1105 dev 1105
1106 dev 1106
1107 dev 1107
1108 dev 1108
Table 19 Test networks
VLAN ID Name
1111 test 1111
1112 test 1112
1113 test 1113
1114 test 1114
Table 20 Ethernet network configuration values
Notes Value Configuration attribute
Ethernet Type
This is the default value displayed on the Create network screen. 2.5 Gb/s Preferred bandwidth
This is the default value displayed on the Create network screen. 10 Gb/s Maximum bandwidth
This is the default value displayed on the Create network screen. Selected Smart link
This is the default value displayed on the Create network screen. Not selected Private network
A.3 Planning the configuration
A.3.1 Planning for installation of the appliance
For the sample data center, assume that you make the following choices before and during
installation:
•
You follow the recommendations in the HP OneView Installation Guide, including:
Choosing a physical host for the appliance virtual machine (VM) that is not targeted to
be managed by this appliance ◦
◦ Choosing a static IP address
◦ Ensuring that the ports required by the appliance are available
•
You allow support personnel to access the appliance.
•
You synchronize the appliance time with the VM host time.
•
When prompted to change the Administrator password, you use the password SDC14u$.
•
You specify the following for the appliance networking settings:
Value Configuration attribute
myhostname.example.com Appliance host name
Manual IPv4 address assignment
255.255.240.0 Subnet mask
256 Step by step: Configuring an example data center using HP OneView