PATLITE NHL - Manual (Page 66)

66
4
4.14 Test Button Setup Screen
The following settings can be used to output an operation when the "TEST" button is pressed.
[Setup Method]
To output an E-mail Sending and TRAP transmission when the "TEST" button is pressed, select the "Active"
radio button.
When sending an E-mail, select the "Active" radio button
1. Select the preferred E-mail subject title and text.
Select the Receiver for the E-mail to be sent to.
The "TRAP Command" for this product to receive when the TRAP condition occurs
OID: 1.3.6.1.4.1.20440.4.1.6.8
Name: trapPatliteTestSwExecuted
2. Click the "Set" button to activate the setup.
Fig. 4.14.1 Test Switch Setup Screen
Table 4.14.1 Test Switch Setup Parameters
Item Contents
Default
Value
Input
Parameter
Setting
Option
E-mail Sending Select the Active/Inactive condition for the E-mail Sending. Inactive — —
Subject Select the E-mail subject title 1: Message — —
Message Select the E-mail message to text 1: — —
Unassigned 1 to 8 Select from 1 to 8 Addresses to send E-mail to. Unassigned — —
Receiver Select the Address to send E-mail to Unused — —
TRAP Transmission Select the Active/Inactive condition for the TRAP Transmission Inactive — —
Note Refer to "3.3 Test Functions" for more information on the test operation.
①
②