PATLITE NHL User Manual

Page 15

Signal Tower Installation

Power Supply Input

LAN Connection

Operation Settings

Start-up

DHCP Setup

Please install this product on a level surface. If necessary, use the
accessories (rubber foot, adhesive seal, support base) if needed
when installing.

Set the volume level switch to "LOW", then push the "TEST" switch
while inserting the AC Adaptor plug into the power outlet. Use the
cable clamp to prevent the power cord from being unintentionally
pulled out. (Refer to 2.3 "Power Supply Input")

Connect the LAN cable to this product.

If this product is unable to connect with a DHCP Server, the Signal
Tower status will start using the flashing pattern2 on all LED units,
then will use the factory default network information set at the
time of shipment. If that condition occurs, then either try again
to connect with a DHCP Server, or manually set up the network.
Refer to "2.5 Network Setup" on how to setup the network
manually. If this product is able to connect to a DHCP Server, in
order to know the network information, it is recommended to use
Patlite's "PNS Manager" software for the NH Series.

Set up the detailed settings after the network environment has
been configured

This product is now ready to be used.

2.1.2 Automtically Setting Up Network

Please

After completing the desired setup configuration, reboot this product

by pressing the "reset" button, or removing the power for a few

seconds and reapplying it for the changes to take effect.

Note

Once the DHCP function is working, it will automatically start up the next time the product is

turned on, or rebooted.