GW Instek GDS-1000A-U Series User Manual - Manual (Page 125)

SAVE/RECALL
125
Recalling the default panel settings
Procedure 1. Press the Save/Recall key. Save/Recall
2. Press Default Setup. The
factory installed setting will
be recalled.
Default
Setup
Setting contents The following is the default panel setting contents.
Acquisition Mode: Normal
Channel Coupling: DC Invert: Off
BW limit: Off voltage: x1
Cursor Source: CH1 Horizontal: None
Vertical: None
Display Type: Vectors Accumulate: Off
Graticule:
Horizontal Scale: 2.5us/Div Mode: Main Timebase
H Pos Adj: Fine Hor Pos: 0
Math Type: + (Add) Channel: CH1+CH2
Position: 0.00 Div Unit/Div: 2V
Measure Item: Vpp, Vavg, Frequency, Duty cycle, Rise Time
Trigger Type: Edge Source: Channel1
Mode: Auto Slope:
Coupling: DC Rejection: Off
Noise Rejection: Off
Utility SaveImage, InkSaver On, Probe squarewave 1kHz
50% duty.