GW Instek GDS-1000A-U Series User Manual - Manual (Page 10)

GDS-1000A-U Series User Manual
10
Power Supply
WARNING
 AC Input voltage: 100 ~ 240V AC, 47 ~ 63Hz
 The power supply voltage should not fluctuate
more than 10%.
 Connect the protective grounding conductor of
the AC power cord to an earth ground.
Fuse
WARNING
 Fuse type: T1A/250V
 To ensure fire protection, replace the fuse only
with the specified type and rating.
 Disconnect the power cord before replacing the
fuse.
 Make sure the cause of fuse blowout is fixed
before replacing the fuse.
Cleaning the
oscilloscope  Disconnect the power cord before cleaning the
oscilloscope.
 Use a soft cloth dampened in a solution of mild
detergent and water. Do not spray any liquid
into the oscilloscope.
 Do not use chemicals containing harsh products
such as benzene, toluene, xylene, and acetone.
Operation
Environment  Location: Indoor, no direct sunlight, dust free,
almost non-conductive pollution (Note below)
 Relative Humidity: ≤ 80%, 40°C or below
≤ 45%, 41°C~50°C
 Altitude: < 2000m
 Temperature: 0°C to 50°C