LumaSense Technologies INNOVA 1314i - Manual (Page 80)

Chapter 7
______________________________________________________________________
_____________________________________________________________________________
BE6030-13 1314i Photoacoustic Gas Monitor LumaSense Technologies A/S
Page 80 of 199
Table 7.6 The range of acceptable values and default value of the alarm
limit for the gases
Display Text Acceptable Values Default
Value
GAS A HIGH ALARM LIMIT 1
n
à
_____PPM
0-1000000ppm Blank
GAS A HIGH ALARM LIMIT 1
n à _____mg/m3
Depends on the molecular
weight of the gas
Blank
n à = A to W
Action: this provides you with 3 ways to trigger the alarm. One or
more of the options can be selected simultaneously.
Monitor Beep: when an alarm is triggered the monitor makes a
beeping noise.
Monitor Relay 1 & Monitor Relay 2: selecting these options
enables you to connect the alarms to a variety of either audio
(for example, a siren) and/or visual (for example a flashing
light) alarm systems.
Active Alarms: only the gases, which you have selected and
activated, are shown in this field.
7.2.1 Measurement Set-up – Stand-alone Use
The philosophy of the instructions is described in Chapter 3 .
To enter the Set-Up Tree, press SET-UP and the monitor displays
the following screen text.
1. Press S1 to enter the MEASUREMENT branch. The new text
displays two branches.
SELECT SET_UP BRANCH
MEASUREMENT FORMAT CONFIGURATION