LumaSense Technologies INNOVA 1314i - Manual (Page 45)

Chapter 4
______________________________________________________________________
_____________________________________________________________________________
BE6030-13 1314i Photoacoustic Gas Monitor LumaSense Technologies A/S
Page 45 of 199
Then press ¿ again to accept the task number.
The following text appears on the display screen:
5. Press S1 to start the monitoring task.
The following warning then appears on the display:
Display Memory is where the Monitor stores the results of all
measurements while it is performing a monitoring task. If the
monitoring task is stopped and then started again all the data
already collected will be deleted from Display Memory. However, the
data in Display Memory can be copied into and stored in the
Monitor’s Background Memory. This operation is described in section
9.2 .
6. Press S1.
The following text then appears on the screen:
MEASUREMENT IN PROGRESS
RESULTS NOT YET AVAILABLE
7. When the first measurement cycle is complete the Monitor will
automatically display the results and update them every time a
new measurement cycle is completed. An example is shown
below:
ACTIVE TASK: MONITORING TASK NUMBER 1
START TASK DELAYED TASK CHANGE TASK
WARNING: DISPLAY MEMORY WILL BE DELETED
PROCEED STOP