LumaSense Technologies INNOVA 1314i User Manual
Page 54
Chapter 4
______________________________________________________________________
_____________________________________________________________________________
BE6030-13
1314i Photoacoustic Gas Monitor
LumaSense Technologies A/S
Page 54 of 199
A:
(the name of the gas being measure by Filter A will appear here)
972.06 mBar
2014-01-16 09:50:32 ________ 7.42 mg/m3
A:
(the name of the gas being measure by Filter A will appear here)
972.06 mBar
2014-01-16 09:51:33 _________ 7.43 mg/m3
Press u so you can scroll through the list showing water-vapour’s
results.
If you do not wish to view the results anymore, press
¿
, this acts as
a “go to head” function.
4.3.10 Changing Gas-concentration Units after a Monitoring
Task
The unit mg/m
3
was chosen for gas concentrations in the monitoring
task, which was set up in
. As long as mg/m
3
is the
active concentration unit (that is, the unit selected while operating
in Set-Up mode), this is the unit which will be used to express gas
concentrations on the display screens of the PC and the Monitor. It is
also the unit when print-outs of monitoring task data are made from
the Monitor. However, the user can express the measured gas
concentrations in ppm:
1. Press SET-UP S3 S2 S3 and then SET-UP.
2. Use q to scroll through the results of the monitoring task no. 1
displayed on the screen. Notice that the gas concentration units
have been changed to ppm.
In a similar way the humidity unit for water vapour and the pressure
unit can be changed.
4.3.11 Changing the Humidity Unit after a Monitoring Task
1. Press SET-UP S3 S2 and then q to reach the following
display:
2. Press
¿
and use the direction keys to display ppm.
3. Press
¿
to accept the unit of ppm.
HUMIDITY UNIT Tdew
PRESS ENTER TO CHANGE VALUE