LumaSense Technologies INNOVA 1314i - Manual (Page 29)

Chapter 3
______________________________________________________________________
_____________________________________________________________________________
BE6030-13 1314i Photoacoustic Gas Monitor LumaSense Technologies A/S
Page 29 of 199
4. To select the AUTO flushing mode, press S1. The following text is
displayed.
This branch does not divide again. At this stage you are able to
define the parameters in this branch of the tree using the direction
push-buttons.
If the branch had divided again, it is a simply process of using the
correct “select” push-button to continue down the desired branch.
Parameters that are already selected are displayed either with a
cursor under the current selection or the value is displayed on the
top line.
When the correct value or parameter is already selected, you can
continue on through the tree using the ▼direction push-button.
To exit SET-UP mode press SET-UP
Defining parameters is covered in section 6.1 .
The procedures in the example above are common to all the
situations where the “select” push-buttons can be used to access the
different levels in the monitor.
LENGTH OF SAMPLING TUBE 00.00 m
PRESS ENTER TO CHANGE VALUE