Reaching the diagnostics menu, Diagnostics menu, Factory-diagnostics – Watlow Series 998 User Manual
Page 94
→
[Diag]
Diagnostics Menu
µ
[Fcty]
Factory Menu Prompt
↓
?
µ
[dAtE]
Factory Ship Date
↓
?
µ
[SOFt]
Software Revision
↓
[Sn--]
µ
[----]
Serial Number
↓
?
µ
[AMb]
Ambient Temperature
↓
?
µ
[`gnd]
Ground A/D Count
↓
?
µ
[`rEF]
Ambient A/D count
↓
?
µ
[cnt1]
Input 1 A/D count
↓
?
µ
[cnt2]
Input 2 A/D count
↓
?
µ
[ity1]
Input 1 Module Type
↓
?
µ
[ity2]
Input 2 Module Type
↓
?
µ
[Oty1]
Output 1 Module Type
↓
?
µ
[Oty2]
Output 2 Module Type
↓
?
µ
[Oty3]
Output 3 Module Type
↓
?
µ
[Oty4]
Output 4 Module Type
↓
?
µ
[diSP]
Test Displays
↓
?
←
µ
[tout]
Test Outputs
6.8
WATLOW Series 998 User’s Manual
Factory Menus, Chapter 6
Factory-Diagnostics
Reaching the Diagnostics Menu
❷ Use the Up-arrow > key to step from
the Panel Lockout Menu [PLOC] to the
Diagnostics Menu [diag].
❶ Press the Up-arrow > and Down-arrow
< keys together and hold until the
[`SEt] prompt appears in the lower dis-
play. Press and hold again until the [Fcty]
prompt appears in the lower display.
Panel
Lockout
Menu
p. 6.2
Diagnostics
Menu
p. 6.8
Calibration
Menu
p. 6.14
[PLOC]
[Fcty]
[diAg]
[Fcty]
[`CAL]
[Fcty]
>
>
>
❸ Press the Mode key µ to step through
the prompts.
❹ Press the Up-arrow key > or the
Down-arrow key < to select one of the
prompt values.
[`OFF]
[tout]
[out1]
[tout]
[out4]
[tout]
…
>
>
>
>
Figure 6.8 -
The Diagnostics Menu.
NOTE:
In the Diagnostics Menu
only the values of
[dISP]
and
[tout]
can be
changed.
Enter your settings,
from the controller’s
upper display.