Watlow Series 998 - Manual (Page 87)

TL TL W WA
PROCESS
DISPLAY
MODE
1A 2A 1B 2B
CH A
CH B
SERIES 998
AUTO
MAN
[InPt]
[`SEt]
TL TL W WA
PROCESS
DISPLAY
MODE
1A 2A 1B 2B
CH A
CH B
SERIES 998
AUTO
MAN
[PLOC]
[Fcty]
WATLOW Series 998 User’s Manual 6.1 Factory Menus, Chapter 6
Navigating the Factory Menus
To reach the Factory menus, begin in the Display Loop and press the Up-
arrow > and Down-arrow < keys together and hold for three seconds.
The Setup prompt [`SEt] will appear in the lower display. Press and hold
the Up-arrow and Down-arrow keys together again for three seconds until
the Factory Menu prompt [Fcty] appears in the lower display. The
Factory menus will not appear if the hardware lockout DIP is set to on.
(See Chapter 1 for more information on DIP switch settings.) The three
Factory menus are: Panel Lockout [PLOC]; Diagnostics [diAg]; and
Calibration [`CAL]. Upon reaching [Fcty] press the Up-arrow or Down-
arrow key to select a menu and the Mode key µ to step through a menu.
You will not see every prompt in any of these menus. The controller’s con-
figuration and model number determine which prompts appear. After
stepping through each menu, the Series 998 returns to the Factory Menu
prompt. Use the Up-arrow or Down-arrow key to select the next menu, or
use the Mode key to advance through the same menu again. To move
backwards through the menu hold the Mode key down and press the Up-
arrow key. Press the Up-arrow or Down-arrow key to change the prompt
setting.
Chapter 6 The Factory Menus
Figure 6.1 -
Navigating the
Factory Menus.
Panel
Lockout
Menu
p. 6.2
Diagnostics
Menu
p. 6.8
Calibration
Menu
p. 6.14
[PLOC]
[Fcty]
[diAg]
[Fcty]
[`CAL]
[Fcty]
>
> >
❶ Press > and < together and hold until [`SEt]
appears in the lower display. Press and hold again
until [Fcty] appears in the lower display.
❷ Press > to select one of the Factory menus.
NOTE:
Press the Display
key
∂ to return to
the Display Loop
from any point in
any menu.
NOTE:
The Factory Menus
can only be entered
when the Setup
prompt
[`SEt] is
displayed.
NOTE:
The Factory Menus
will not appear if the
hardware lockout
DIP is set to on.
See Chapter 1 for
more information.