Watlow Series 998 - Manual (Page 60)

4.32 WATLOW Series 998 User’s Manual Setup Menus, Chapter 4
Setup-Global
❸ Press the Mode key µ to step
through the prompts.
❹ Press the Up-arrow key > or
the Down-arrow key < to select
one of the prompt values.
❶ Begin in the Display Loop, and
press the Up-arrow > and Down-
arrow < keys simultaneously for
three seconds to reach the Setup
menus.
❷ Press the Up-arrow key > to
select one of the Setup menus.
Reaching the Global Menu
Figure 4.32 -
The Global Menu.
*Prompts may not appear, depending
on controller configuration.
→ [gLbL] Global Menu
µ
[`SEt] Setup Menus
↓ ?
µ
[`C_F] *Celsius-Fahrenheit (page 4.33)
↓ ?
µ
[FAIL] Failure Mode
↓ ?
µ
[`err] Error Latching
↓ ?
µ
[`Ei1] *Event Input 1
↓ ?
µ
[Anun] Annunciator
↓ ?
µ
[AtSP] Auto-tune Set Point (page 4.35)
↓ ?
µ
[rP`A] Ramping CH A
↓ ?
µ
[rT`A] Ramp rate CH A
↓ ?
µ
[rP`b] Ramping CH B
↓ ?
[rt`b] Ramp rate CH B ←
µ
Enter your settings,
from the controller’s
upper display.
[Inpt]
[`SEt]
[Otpt]
[`SEt]
[COM]
[`SEt]
[GLbl]
[`SEt]
> > > >
[``°f]
[`C_F]
[``°C]
[`C_F]
>
>
Input Output Global Communications
Menu Menu Menu Menu
p. 4.2 p. 4.16 p. 4.32 p. 4.38