Watlow Series 998 - Manual (Page 66)

4.38 WATLOW Series 998 User’s Manual Setup Menus, Chapter 4
Setup-Communications
Reaching the Communications Menu
❶ Begin in the Display Loop, and press the
Up-arrow > and Down-arrow < keys
simultaneously for three seconds to reach
the Setup Menus.
❷ Press the Up-arrow key > to select one
of the Setup Menus.
❸ Press the
Mode key µ
to step through
the prompts.
❹ Press the Up-arrow key > or the
Down-arrow key < to select one of the
prompt values.
*Prompts may not appear, depending on controller
configuration.
NOTE:
The Communications Menu
appears only on controllers
equipped with communications
hardware (99__-____-_R__ or
99__-____-_S__).
See Data Communications with
the Series 988 Family of
Controllers for detailed informa-
tion on communications.
→ [COM] Communications Menu
µ
[`SEt] Setup Menus
↓ ?
µ
[bAUd] Baud Rate
↓ ?
µ
[dAtA] Data Bits and Parity
↓ ?
µ
[Prot] Protocol Type
↓ ?
µ
[Addr] *Address
↓ ?
←
µ [IntF] *Interface Type
Figure 4.38 -
The Communications
Menu.
[Inpt]
[`SEt]
[Otpt]
[`SEt]
[COM]
[`SEt]
[GLbl]
[`SEt]
> > > >
Input Output Global Communications
Menu Menu Menu Menu
p. 4.2 p. 4.16 p. 4.32 p. 4.38
[FULL]
[Prot]
[``on]
[Prot]
>
>
TL W WA
PROCESS
DISPLAY
MODE
1A 2A 1B 2B
CH A
CH B
SERIES 998
AUTO
MAN
[COM]
[`SEt]