Watlow Series 998 - Manual (Page 69)

TL TL W WA
PROCESS
DISPLAY
MODE
1A 2A 1B 2B
CH A
CH B
SERIES 998
AUTO
MAN
[`998]
[`998]
TL TL W WA
PROCESS
DISPLAY
MODE
1A 2A 1B 2B
CH A
CH B
SERIES 998
AUTO
MAN
[`SYS]
[OPEr]
WATLOW Series 998 User’s Manual 5.1 Operation Menus, Chapter 5
Navigating the Operation Menus
To reach the Operation Menus, begin in the Display Loop and press the
Mode key µ. Depending on the controller configuration, either the Set
Point 2A prompt [SP2A], the Set Point 2B prompt [SP2B] or the Operation
Menu prompt [OPEr] will appear in the lower display. The three Operation
Menus are: System [`SYS]; PID A [PidA]; and PID B [Pidb]. Use the
Mode key µ to step past the Set Point 2A prompt [SP2A] or the Set Point
2B prompt [SP2b], if they appear (see prompt information). Upon reaching
the Operation Menu prompt [OPEr] use the Up-arrow > or Down-arrow
< key to select a menu and the Mode key µ to step through a menu.
You will not see every prompt in any of these menus. The controller’s con-
figuration and model number determine which prompts appear. After
stepping through each menu, the Series 998 returns to the Operation
Menu prompt. Use the Up-arrow and Down-arrow keys to select the next
menu, or use the Mode key to advance through the same menu again. To
move backwards through the menu hold the Mode key down and press the
Up-arrow key. Use the Up-arrow or Down-arrow key to change the prompt
setting.
Chapter 5 The Operation Menus
Figure 5.1 -
Navigating the
Operation Menus.
System
Menu
p. 5.2
PID A
Menu
p. 5.8
PID B
Menu
p. 5.13
[`998]
[SP2A]
Set Point 2A
[`998]
[SP2B] Set Point 2B
µ
µ
[`SYS]
[OPEr]
[PIdA]
[OPEr]
[PIdb]
[OPEr]
>
> >
❶ Begin in the Display Loop, and press the Mode key
to reach the Set Point 2A prompt [SP2A], the Set Point
2B prompt [SP2B] or the Operation Menu [OPEr].
❷ Use the Mode key to step past the Set Point 2A
prompt or the Set Point 2B prompt, if they appear (see
prompt information). Upon reaching the Operation
Menu prompt [OPEr] use the Up-arrow key to select a
menu.
NOTE:
Press the Display
key
∂ to return to
the Display Loop
from any point in
any menu.