Watlow Series 998 - Manual (Page 47)

WATLOW Series 998 User’s Manual 4.19 Setup Menus, Chapter 4
Setup-Output
Output 2A
Set the way that output 2A will respond to a difference between the
set point and an input variable.
• [``Ht] select reverse action, so that output 2A responds when the input
signal is less than the set point. This prompt only appears if [Ot1A] is set
to [``CL].
• [``CL] select direct action, so that output 2A responds when the input
signal is more than the set point. This prompt only appears if [Ot1A] is
set to [``Ht].
[Ot2A] This prompt appears only if channel A output is something other
than a process output (99__-__F_-____).
Default
↓
[``no] [``Ht] [``CL]
[Ot2A] [Ot2A] [Ot2A]
[Ot2A]