Watlow Series 998 - Manual (Page 14)

Installing
Installation and Wiring, Chapter 2 2.2 WATLOW Series 998 User’s Manual
Installing the Series 998
Installing and mounting requires access to the back of the panel.
1. Make a panel cutout.
2. To remove the controller chassis from its case, press in firmly on the two
tabs on one side or the top of the bezel until they unsnap, then unsnap
the two tabs on the opposite side or the bottom. Pull the chassis out of
the case by gently rocking it.
3. Slide the case into the panel cutout. Check to see that the gasket is
not twisted, and is seated within the case bezel flush with the panel.
Slide the mounting collar over the back of the control.
Panel Adjustable
Mounting Bracket
Bezel
External Gasket
Mounting Collar
Release Tabs
Top and Bottom (996 or 998)
or Side (997 or 999) View
Mounting Slots
Side (996 or 998)
or Top and Bottom (997 or 999) View
˜
NOTE:
Removing the con-
troller chassis from
its case makes
mounting easier.
Figure 2.2 -
Side and top view.