Watlow Series 998 - Manual (Page 81)

WATLOW Series 998 User’s Manual 5.13 Operation Menus, Chapter 5
Operation-PID B
*Prompts may not
appear, depending on
controller configuration.
→ [PIDb] Channel B PID Menu
µ
[OPEr] Operation Menus
↓ ?
µ
[Pb1B] Proportional Band, Output 1B (page 5.14)
↓ ?
µ
[rE1b] *Reset, Output 1B
↓ ?
µ
[It1b] *Integral, Output 1B
↓ ?
µ
[rA1b] *Rate, Output 1B
↓ ?
µ
[dE1b] *Derivative, Output 1B
↓ ?
µ
[Ct1b] *Cycle Time, Output 1B
↓ ?
µ
[Pb2b] Proportional Band, Output 2B (page 5.14)
↓ ?
µ
[rE2b] *Reset, Output 2B
↓ ?
µ
[It2b] *Integral, Output 2B
↓ ?
µ
[rA2b] *Rate, Output 2B
↓ ?
µ
[dE2b] *Derivative, Output 2B
↓ ?
µ
[Ct2b] *Cycle Time, Output 2B
↓ ?
←
µ
[db`b] *Dead Band B
Enter your settings,
from the controller’s
upper display.
System
Menu
p. 5.2
PID A
Menu
p. 5.8
PID B
Menu
p. 5.13
[`998]
[SP2A]
Set Point 2A
[`998]
[SP2B] Set Point 2B
µ
µ
[`SYS]
[OPEr]
[PIdA]
[OPEr]
[PIdb]
[OPEr]
>
> >
…
…
…
[`)00]
[dE1b]
[`)01]
[dE1b]
[`(99]
[dE1b]
[`)02]
[dE1b]
> > >
Figure 5.13 -
The PID B Menu.
Reaching the PID Menus
❷ Use the Mode key µ to step
past the Set Point 2A prompt
[SP2A] or the Set Point 2B prompt
[SP2B], if they appear (see prompt
information). Upon reaching the
Operation Menu prompt [OPEr] use
the Up-arrow key > to select a
menu.
❸ Press the Mode key µ to step
through the prompts.
❹ Press the Up-arrow key > to
step through the prompt values.
The Down-arrow key < backs
through the values.
❶ Begin in the Display Loop, and
press the Mode key µ to reach
the Set Point 2A prompt [SP2A], the
Set Point 2B prompt [SP2B] or the
Operation Menu [OPEr].