Reaching the pid menus, Pid a menu, Operation-pid a – Watlow Series 998 User Manual
Page 76: Channel a pid menu
5.8
WATLOW Series 998 User’s Manual
Operation Menus, Chapter 5
System
Menu
p. 5.2
PID A
Menu
p. 5.8
PID B
Menu
p. 5.13
[`998]
[SP2A]
Set Point 2A
[`998]
[SP2B]
Set Point 2B
µ
µ
[`SYS]
[OPEr]
[PIdA]
[OPEr]
[PIdb]
[OPEr]
>
>
>
❶ Begin in the Display Loop, and
press the Mode key µ to reach the
Set Point 2A prompt [SP2A], the Set
Point 2B prompt [SP2B] or the
Operation Menu [OPEr].
❷ Use the Mode key µ to step
past the Set Point 2A prompt
[SP2A] or the Set Point 2B prompt
[SP2B], if they appear (see prompt
information). Upon reaching the
Operation Menu prompt [OPEr] use
the Up-arrow key > to select a
menu.
Figure 5.8 -
The PID A Menu.
❸ Press the Mode key µ to step
through the prompts.
❹ Press the Up-arrow key > to
step through the prompt values.
The Down-arrow key < backs
through the values.
…
…
…
[`)00]
[dE1A]
[`)01]
[dE1A]
[`(99]
[dE1A]
[`)02]
[dE1A]
>
>
>
Reaching the PID Menus
Operation-PID A
*Prompts may not
appear, depending on
controller configuration.
→
[PIDA]
Channel A PID Menu
µ
[OPEr]
Operation Menus
↓
?
µ
[Pb1A]
Proportional Band, Output 1A (page 5.9)
↓
?
µ
[rE1A]
*Reset, Output 1A
↓
?
µ
[It1A]
*Integral, Output 1A
↓
?
µ
[rA1A]
*Rate, Output 1A
↓
?
µ
[dE1A]
*Derivative, Output 1A
↓
?
µ
[Ct1A]
*Cycle Time, Output 1A
↓
?
µ
[Pb2A]
Proportional Band, Output 2A (page 5.9)
↓
?
µ
[rE2A]
*Reset, Output 2A
↓
?
µ
[It2A]
*Integral, Output 2A
↓
?
µ
[rA2A]
*Rate, Output 2A
↓
?
µ
[dE2A]
*Derivative, Output 2A
↓
?
µ
[Ct2A]
*Cycle Time, Output 2A
↓
?
←
µ
[db`A]
*Dead Band A
Enter your settings,
from the controller’s
upper display.