Watlow Series 998 - Manual (Page 59)

WATLOW Series 998 User’s Manual 4.31 Setup Menus, Chapter 4
Setup-Output
Retransmit High Limit
Select the high limit for the retransmit signal at output 3.
• The default value is equal to [`rH1] or [`rH2] (in the Input Menu)
depending on whether [Aout] is set to [PrcA] or [Prcb].
[`ArH] This prompt appears only on controllers equipped with retransmit
hardware (99__-____-M___ or 99__-____-N___) and with [Aout] not set to
[``no].
[`ArL] … [9999]
[`ArH] [`ArH]
Retransmit Calibration Offset
Select an offset value for the retransmit signal at output 3.
[ACAL] This prompt appears only on controllers equipped with retransmit
hardware (99__-____-M___ or 99__-____-N___) and with [Aout] not set to
[``no].
If Default
↓ ↓
[``°F] [-999] … [```0] … [`999]
[`C_F] [ACAL] [ACAL] [ACAL]
(Global Menu)
[``°C] [-555] … [[```0] … [`555]
[`C_F] [ACAL] [ACAL] [ACAL]
(Global Menu)
[-999] … [```0] … [`999]
units
a process input [ACAL] [ACAL] [ACAL]
is selected
[`ArH]
[ACAL]