Annunciator, Auto-tune set point, Ramping function for channel – Watlow Series 998 User Manual

Page 63: Anun] [atsp, Rp`a, Setup-global, Ramping function for channel a

WATLOW Series 998 User’s Manual

4.35

Setup Menus, Chapter 4

Annunciator

Select whether alarm messages will flash in the lower display.

[Anun] This prompt always appears.

Default

↓

[``On]

[`OFF]

[Anun]

Auto-tune Set Point

Select the percentage at which the controller will auto-tune the cur-
rent control set point.

[AtSP] This prompt always appears.

Default

↓

[``50]

…

[``90]

…

[`150]

[AtSP]

Ramping Function for Channel A

Select when channel A will enter ramping mode.

• [Strt] Activates ramping on power up only.

• [StPt] Activates ramping on power up and any set point change.

[rP`A] This prompt always appears.

Default

↓

[`OFF]

[Strt]

[StPt]

[rP`A]

[Anun]

[AtSP]

Setup-Global

[rP`A]

NOTE:
Lower display alter-
nately flashes

{`rp`}

and lower

display value when
ramping is in
process.