Watlow Series 998 - Manual (Page 50)

4.22 WATLOW Series 998 User’s Manual Setup Menus, Chapter 4
Setup-Output
Output 2B
Set the way that output 2B will respond to a difference between the
set point and an input variable.
• [``Ht] select reverse action, so that output 2B responds when the input
signal is less than the set point.
• [``CL] select direct action, so that output 2B responds when the input
signal is more than the set point.
[Ot2b] This prompt appears only if channel B output is something other
than a process output (99__-___F-____).
Default
↓
[``Ht] [``CL] [``no]
[Ot2b] [Ot2b] [Ot2b]
Hysteresis 2B
Select the switching hysteresis for output 2B. This determines the
change in temperature or process units needed to turn the output from
full off to full on.
[HY2b] This prompt does not appear if output 2 is a process output.
If Default
↓ ↓
[``°F] [```1] … [```3] … [`999]
[`C_F] [HY2b] [HY2b] [HY2b]
(Global Menu)
[``°F] & [`r†d] [``)1] … [``#0] … [`9(9]
[`C_F] [`In1] [HY2b] [HY2b] [HY2b]
(Global Menu) (Input Menu)
[``°C] [```1] … [```2] … [`555]
[`C_F] [HY2b] [HY2b] [HY2b]
(Global Menu)
[``°C] & [`r†d] [``)1] … [``@0] … [`5%5]
[`C_F] [`In1] [HY2b] [HY2b] [HY2b]
(Global Menu) (Input Menu)
[```1] … [```3] … [`999]
units
a process input [HY2b] [HY2b] [HY2b]
is selected
[Ot2b]
[HY2b]