Latching 3, Silencing 3, Lat3] [sil3 – Watlow Series 998 User Manual

Page 54: Setup-output

4.26

WATLOW Series 998 User’s Manual

Setup Menus, Chapter 4

Setup-Output

Latching 3

Select whether alarm 3 will be latching or non-latching. A latching
alarm [`LAt] must be turned off manually. A non-latching alarm [`nLA]
turns off when an alarm condition no longer exists.

[LAt3] This prompt appears only on controllers equipped with output 3
hardware (99__-____-B___, or 99__-____-C___, or 99__-____-K___ or 99__-
____-J___) and with [`Ot3] (Output Menu) set to [`AL3] or [AL3n].

Default

↓

[`nLA]

[`LAt]

[LAt3]

Silencing 3

Select silencing to inhibit alarm 3 on startup and to allow the opera-
tor to reset the alarm output, not the visual display.

• Silencing disables the alarm until the signal is between [A3LO] and

[A3HI].

[SIL3] This prompt appears only on controllers equipped with output 3
hardware (not 99__-____-A___) and with [`Ot3] (Output Menu) set to
[`AL3] or [AL3n].

Default

↓

[`OFF]

[``On]

[SIL3]

[LAt3]

[SIL3]

NOTE:
See Chapter 7 for
more information
on alarms.