Watlow Series 998 - Manual (Page 49)

WATLOW Series 998 User’s Manual 4.21 Setup Menus, Chapter 4
Setup-Output
Output 1B
Set the way that output 1B will respond to a difference between the
set point and an input variable.
• [``Ht] select reverse action, so that output 1B responds when the input
signal is less than the set point.
• [``CL] select direct action, so that output 1B responds when the input
signal is more than the set point.
[Ot1b] This prompt always appears.
Default
↓
[``H]t] [``CL] [``no]
[Ot1b] [Ot1b] [Ot1b]
Hysteresis 1B
Select the switching hysteresis for output 1B. This determines the
change in temperature or process units needed to turn the output from
full off to full on.
[HY1b] This prompt does not appear if output 1 is a process output.
If Default
↓ ↓
[``°F] [```1] … [```3] … [`999]
[`C_F] [HY1b] [HY1b] [HY1b]
(Global Menu)
[``°F] & [`r†d] [``)1] … [``#0] … [`9(9]
[`C_F] [`In1] [HY1b] [HY1b] [HY1b]
(Global Menu) (Input Menu)
[``°C] [```1] … [```2] … [`555]
[`C_F] [HY1b] [HY1b] [HY1b]
(Global Menu)
[``°C] & [`r†d] [``)1] … [``@0] … [`5%5]
[`C_F] [`In1] [HY1b] [HY1b] [HY1b]
(Global Menu) (Input Menu)
[```1] … [```3] … [`999]
units
a process input [HY1b] [HY1b] [HY1b]
is selected
[Ot1b]
[HY1b]