Teledyne LeCroy Summit T24 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 195)

Summit T24 PCI Express Multi‐Lane Protocol Analyzer User Manual 183
Using the CATC Trace Navigator Teledyne LeCroy
Navigator Panes: This button has two purposes: To select which Navigator panes appear
and to bring up the Navigator legend. The legend determines how information is shown in
the panes.
10.8.3 Navigator Ranges
You set the viewing range by dragging the yellow range delimiters along the slider. To set
the lowest packet viewable, drag the top delimiter up. As you do so, a tool tip appears to
indicate the current range. Stop dragging when you reach the desired lowest packet.
To set the highest packet viewable, drag the bottom delimiter down. Stop when the tool
tip indicates you are at the desired highest packet.
.
10.8.4 To Determine Current Position
In addition to the two range delimiters, the slider has a blue current‐position indicator
(see above). The current‐position indicator shows where you are in the CATC Trace display
with respect to the possible viewing range.
For example, suppose you set viewing range to packet 0 through packet 500 (the top
range delimiter is at packet 0, and the bottom range delimiter is at packet 500). If you
then move the current‐position indicator on the slider to midway between the top and
bottom delimiters, then packet 250 appears in the middle of the CATC Trace display.
10.8.5 To Reset Navigator Range
You can reset the Navigator range using the toolbar Navigator Range button. Press the
button to bring up the Navigator Range drop‐down menu (see
Figure 10.20 on page 184 ).