Teledyne LeCroy Summit T24 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 18)

Teledyne LeCroy Summit T24 Front Panel Description
6 Summit T24 PCI Express Multi‐Lane Protocol Analyzer User Manual
2.3 Summit T24 Front Panel Description
When powered on, the Summit T24 activates the user‐accessible controls and LEDs on
the front panel.
WARNING: Do not open the enclosure. There are no operator serviceable parts inside.
Refer servicing to Teledyne LeCroy.
The controls and LEDs are:
 Power LED: Lights when power is On.
 Status LED: Displays the connection status of the link.
 Red ‐ Error condition. Try using the PETracer application to clear the error.
Please contact the factory if this does not work.
 Green ‐ Configuring system.
 Purple ‐ Waiting for connection.
 Blue - Unit ready/connected.
 Speed LEDs: Indicates current speed the analyzer is using for the Upstream
direction.
 Upstream [3:0] LEDs: Indicates which Upstream Lanes are currently showing
activity.
 Upstream [3:0] and Downstream [3:0] connector: Connection to the probe for
the capture of both upstream and downstream directions of the link.
 Downstream [3:0] LEDs: Indicates which Downstream Lanes are currently show‐
ing activity.
 Speed LEDs: Indicates current speed the analyzer is using for the Downstream
direction.
2.4 Summit T24 Rear Panel Description
The Summit T24 rear panel contains:
 USB Type B Host Machine Connector: To connect the Analyzer to the host
machine using a USB connection.
 Sync /Data: Allows multiple Teledyne LeCroy analyzers to send synchronization
and control messages to one another. This is also used for Trigger in and Trigger
Out. The minimal pulse width for Trigger In is 20ns.
 DC IN: 12 V, 3 A
 Power Switch (black): 1 = On and 0 = Off.